Police Vehicle Automotive Small Body Hole Patch Plug holes up to 3/4" I.D.

Description

Can’t find a solution to fill a hole in your former police cruiser?  Check this out!
Two (2 each) Made in U.S.A. pressure sensitive adhesive hole patches made from automotive grade urethane.
Featuring a strong industrial adhesive backing for peel and stick installation (50 degrees minimum installation temp).
Specifically designed to cover any circular hole in a vehicle up to 3/4” diameter ( 0.75") with a margin of overlap.  It is ideal for light bar wiring harness holes in police vehicle roofs, antenna holes or holes in the firewall. Unlike the rubber or cheap plastic caplug hole plugs, this patch has a very stealthy low profile appearance.
Patch Dimensions:
1.0” OD by .060” thick
Colors:
Paintable Gloss White, or Gloss Black
,
blends nicely into white body panels with a low profile look without the unsightly dull black bump appearance like the rubber plugs.
These patches are compatible with all standard automotive finishes including basecoat / clearcoat.  Prep and paint as you would any automotive spot refinish repair.
Installation:
Clean all wax, spent adhesive residue, RTV silicone and any other foreign substances around the hole to be filled. For particularly stubborn spots, use a detergent solution then rinse with clean water and dry thoroughly.  Use the included alcohol wipe the area then carefully peel the backing off the patch and center over your hole pressing down around the outer edges only.  Avoid “touch” type car washes for 24 hours and surface must be at 50 degrees F minimum.  It may also be helpful to apply painters tape in an "X" across the patch for 12-24 hours then remove.
Let us know if you have any questions.
Thanks for looking!
Nennoguy
Nenno Products LLC